Search results for "Alumina membranes"

Electrochemical cell for the preparation of large area Anodic Alumina Membranes

2009

Real-time polarimetric biosensing using macroporous alumina membranes

2013

We report the first demonstration of real-time biosensing in free standing macroporous alumina membranes. The membranes with their 200 nm diameter pores are ideal candidates for biosensing applications where fast response times for small sample volumes are needed as they allow analytes to flow through the pores close to the bioreceptors immobilized on the pores walls. A bulk refractive index sensitivity of 5.2x10 -6 refractive index units was obtained from signal responses to different concentrations of NaCl solutions flowing through the pores. Finally, after functionalizing the alumina pore surfaces with an epoxysilane and then spotting it with β-Lactoglobulin protein, the interactions bet…

Anodic Alumina Membranes for Fuel Cell Technology and Nanostructure Template -assisted Deposition

2009

Effect of temperature on the growth of alfa-PbO2 nanostructures

2010

Abstract Ordered arrays of α-PbO 2 nanostructures were grown by galvanostatic anodic deposition into the channels of alumina templates. Electrodepositions were performed in an aqueous solution containing lead acetate and sodium acetate at pH 5.4. Bath temperature and electrodeposition time were varied to check their effect on the growth of nanostructures. It has been found that filling of alumina pores is independent of the time and electrodeposition temperature, whilst height and growth kinetics of nanostructures vary with both parameters. Temperature greatly influences morphology: wires grown at room temperature consisted of clusters of particles, leading to poorly compact structures, whi…

Electrosynthesis of Ce–Co Mixed Oxide Nanotubes with High Aspect Ratio and Tunable Composition

2008

Cerium oxide and cobalt oxides have attracted the interest of several researchers due to their potential application in several technological fields electrochromism, lithium batteries, catalysis, etc.. Ceria has been used as a promoter in the so-called “three-way catalyst” for the control of toxic emission from automobile exhaust. The promotion consists of the enhancement of the noble metal dispersion, as well as stabilization of the supporting medium toward thermal sintering. 1,2 A direct catalytic effect of CeO2 in chemical processes such as water–gas shift reaction or NOx decomposition has been also evidenced. 3,4

Fuel Cell Performances of Bio-Membranes Made of Chitosan-Polyelectrolyte Thin Films and Nanowires into Anodic Alumina Membranes

2012

Chitosan (CS) / Phosphotungstic acid (PTA) polyelectrolytes in the shape of thin films and nanowires supported by Anodic Alumina Membranes (AAM) have been fabricated through solution cast and filtration techniques, respectively. Their ability to function in a H2/O2 fuel cell under mild conditions (room temperature, low humidity and low Pt loading) is proved for the first time. The fabricated membrane electrode assemblies produce power peaks of ~20 mW cm-2 for both films and nanowires. The CS/PTA films (20-40 μm thick) are able to produce a quite constant power density of ~10 mW cm-2 recorded for at least 7 h. The gradual decrease of the power output with time observed for CS/PTA nanowires i…

Influence Of The Electrical Parameters On The Fabrication Of Copper Nanowires Into Anodic Alumina Templates

2009

Abstract Metallic copper nanowires have been grown into the pores of alumina membranes by electrodeposition from an aqueous solution containing CuSO 4 . and H 3 BO 3 at pH 3. In order to study the influence of the electrical parameters on growth and structure of nanowires, different deposition potentials (both in the region where hydrogen evolution reaction is allowed or not) and voltage perturbation modes (constant potential or unipolar pulsed depositions) were applied. In all cases, pure polycrystalline Cu nanowires were fabricated into template pores, having lengths increasing with the total deposition time. These nanowires were self-standing, because they retain their vertical orientati…

Sintesi per via elettrochimica di nanowires di leghe Co-Sn

2008

Fabrication and Photoelectrochemical Behavior of Ordered CIGS Nanowire Arrays for Application in Solar Cells

2010

In this work, we report some preliminary results concerning the fabrication of quaternary copper, indium, gallium, and selenium CIGS nanowires that were grown inside the channels of an anodic alumina membrane by one-step potentiostatic deposition at different applied potentials and room temperature. A tunable nanowire composition was achieved through a manipulation of the applied potential and electrolyte composition. X-ray diffraction analysis showed that nanowires, whose chemical composition was determined by energy-dispersive spectroscopy analysis, were amorphous. A composition of Cu0.203In0.153Ga0.131Se0.513, very close to the stoichiometric value, was obtained. These nanostructures wer…

Anodic Alumina Membranes: From Electrochemical Growth to Use as Template for Fabrication of Nanostructured Electrodes

2022

The great success of anodic alumina membranes is due to their morphological features coupled to both thermal and chemical stability. The electrochemical fabrication allows accurate control of the porous structure: in fact, the membrane morphological characteristics (pore length, pore diameter and cell density) can be controlled by adjusting the anodizing parameters (bath, temperature, voltage and time). This article deals with both the fabrication and use of anodic alumina membranes. In particular, we will show the specific role of the addition of aluminum ions to phosphoric acid-based anodizing solution in modifying the morphology of anodic alumina membranes. Anodic alumina membranes were …